High-pressure cleaning vehicles are divided into road cleaning vehicles and pipeline high-pressure cleaning vehicles. There are still many differences in the production of tops.
The road cleaning vehicle is a professional road cleaning vehicle, and the pipeline high-pressure cleaning vehicle is a professional cleaning sewer.
Today, let’s take a look at this Sinotruk Howo G5X 9.5m3 road cleaning truck!
It is powered by a Weichai 220-horsepower engine, matched with an eight-speed gearbox, with a wheelbase of 4.7 meters, a 3.6-ton front axle, an 8-ton rear axle, 250 single-layer girders, 275/80R22.5 steel tires, and other configurations, with strong bearing capacity.
The whole vehicle is 9.4 meters long, 2.5 meters wide and 3..25 meters high, with a total mass of 18 tons, a curb weight of 8.75 tons, and a rated load of 9.12 tons;
The shape of the tank is square and round, and it is made of a carbon steel plate. The tank is 4.05 meters long, 2.28 meters long, 1.45 meters short, and has an effective volume of 9.5 cubic meters. After anti-corrosion treatment.
The front extension of the car is 1000mm; the side protection and the rear lower protection device are made of Q235A carbon steel, all of which are connected by welding, the rear lower protection dimension is 130×65(mm), and the height above the ground is 410mm;
Optional speed limit device, speed limit 89km/h; production of working platform and auxiliary platform at the rear of the vehicle.
A special device for Sinotruk Howo G5X 9.5m3 road washing vehicle, a Jiangling 87-horsepower auxiliary engine and a GTM high-pressure water pump is installed in front of the tank to drive the front road washing rack;
This flushing rack can also be adjusted left and right, and both ends can be retracted, which can widen the flushing width. The working width is 3.5 meters. There are warning lights installed at both ends, which can give early warning when working.
A work chair and a flushing gun are also installed on the chassis to facilitate flushing; a fence is also made around the chassis, and cooling holes are made on both sides of the chassis to dissipate heat.
The whole vehicle is also equipped with a low-pressure water pump, which can be pumped in and out. A working platform is made at the tail of the tank, and front flushing, rear spraying, and anti-aircraft guns are installed on the platform, which can be used for landscaping.
Install a flushing dust suppression rod on the top of the tail of the tank for dust suppression;
A 20m high-pressure washing reel is also installed at the left rear of the vehicle, with a washing pressure of 10Mpa, which can be used to wash the stains on the road and advertisements on the wall.
This Sinotruk Howo G5X 9.5m3 road cleaning truck is also equipped with a pneumatic ball valve so that some functions can be operated with one key in the cab, which is very convenient.
The vehicle has good workmanship, a wide range of work and high efficiency. Are you optimistic about it?